The Solder Connection

Cartridge heater technology provides soldering and rework performance to suit even the most demanding SMT removal and placement applications.

The cartridges provide fast thermal performance and respond quickly to the load demands.

A small shaft diameter provides access to tightly cramped rework areas and enables the most difficult operations to be performed effortlessly.

MFR-SRC SOLDERING & REWORK SYSTEM
Part No.	Description
MFR-SRC	Soldering and Rework System
INCLUDES
MFR-PS1K	Two Port Universal Voltage Power Supply
MFR-HSR	Soldering and Rework Hand-piece
MFR-WSSR	Soldering Workstand

Contents subject to change without notice

Technical Specifications
MFR-PTZ, MFR-SRC, MFR-PST, MFR-STZ
Ambient Operating Temperature:	10- 40°C
Maximum Enclosure Temperature:	55°C
Input Line Voltage:	100- 240 VAC, grounded circuit
Input Line Frequency:	50/60 Hz
Power Consumption:	65 Watts max.
Output Power:	50 Watts max. at 22°C ambient temperature
Output Frequency:	450 KHz
Power Cord 3-Wire:	183cm (18/3") SJT
Power Supply Dimensions w x d x h:	122mm x 200mm x 152.5mm (4.8" x 8" x 6")
Agency Tested Per:	IEC 61000-6-1,EC 61000-6-3 and UL499, FCC CFR Part 15
Tip-to-Ground Potential:	< 2mV
Tip-to-Ground Resistance:	< 2 ohms
Idle Temperature Stability:	± 1.1°C in still air
Hand-piece Cable Length:	L=71cm (48"), burn proof, ESD safe
Connector:	8-pin power connector
Workstand Dimensions w x d x h:	100 mm x 200 mm x 100 mm (4" x 8" x 4")