MFR DESOLDER SYSTEMS

Versatile Pencil and Pistol Grip Combination Hand-piece System

The MFR Desoldering Systems provides superior thermal transfer to the joint, effectively reflowing the solder and then quickly and efficiently removing all solder. SmartHeat technology makes through-hole Desoldering easy and safe from board damage. The state-of-the-art hand-piece can be adjusted from a pencil to a gun with a simple press of a button. Operators can find the most comfortable and efficient position to tackle the rework challenge. The paper solder collection chamber and filter system is quick and easy to change, and provides low cost maintenance.

Two MFR Desoldering Systems are available. The MFR-DSX system requires shop air for desoldering. If shop air is not available, the MFR-DSI features an internal vacuum pump

	MFR DESOLDER SYSTEMS Part No. Description MFR-DSX Desolder System, External Air MFR-DSI Desolder System, Internal Air Pump INCLUDES   MFR-PS2X Two Port Universal Voltage Power Supply, External Air (MFR-DSX only) MFR-PS2K Two Port Universal Voltage Power Supply, with Internal Air Pump (MFR-DSI only) MFR-HDS Desolder Hand-piece MFR-WSDS Desolder workstand

Contents subject to change without notice"

Complete MFR System for Soldering, Desoldering and Rework

The MFR Solder / Desoldering Systems include both the innovative desoldering hand-piece and the solder/rework cartridge hand-piece to cover all your rework needs.

Two MFR Soldering / Desoldering Systems are available. The MFR-SDX system requires shop air for desoldering. If shop air is not available, the MFR-SDI features an internal pump that provides suction.

	MFR SOLDERING, DESOLDERING & REWORK SYSTEMS Part No. Description MFR-SDX Desolder System, External Air MFR-SDI Solder / Desolder System, Internal Air Pump INCLUDES   MFR-PS2X Two Port Universal Voltage Power Supply External Air (MFR-SDX only) MFR-PS2K Two Port Universal Voltage Power Supply with Internal Air Pump (MFR-DSI only) MFR-HSR Soldering and Rework Hand-piece MFR-WSSR Soldering Workstand MFR-HDS Desoldering Hand-piece MFR-WSDS Desoldering Workstand

Contents subject to change without notice"

	Technical Specifications MFR-DSI, MFR-SDI, MFR-DSX, MFR-SDX Ambient Operating Temperature: 10- 40°C Maximum Enclosure Temperature: 55°C Input Line Voltage: 100- 240 VAC, grounded circuit Input Line Frequency: 50/60 Hz Power Consumption: 90 Watts max. Output Power: 50 Watts max. at 22°C ambient temperature Output Frequency: 450 KHz Power Cord 3-Wire: 183cm (18/3") SJT Power Supply Dimensions w x d x h: 170mm x 200mm x 152.5mm (7" x 8" x 6") Agency Tested Per: IEC 60335-2-45 and UL499, FCC CFR Part 15 Tip-to-Ground Potential: < 2mV Tip-to-Ground Resistance: < 2 ohms Idle Temperature Stability: ± 1.1°C in still air Hand-piece Cable Length: L=71cm (48"), burn proof, ESD safe Connector: 8-pin power connector Workstand Dimensions w x d x h: 100 mm x 200 mm x 100 mm (4" x 8" x 4") Recommended Air Pressure Input: 450kPa (65PSI) - shop air versions only